The Dunlop® SnugBoot® exists out of six extraordinary parts:

PUROTEX UPPER Not neoprene, but a 4-layer material that is 100% waterproof outside and breathable inside.

SNUG LAST Not a boot-last, but a foot-last developed for perfect fit and comfort.

PUROFORT® SHAFT Not rubber, but Dunlop's proprietary Purofort® compound that is lighter, warmer, and stronger.

STABILITY FIX Glass-fibre reinforced shoehorn, heel counter, and shank for optimal support.

METAL-FREE PROTECTION Protective toecap and midsole for protection against falling and piercing objects.

ALL TERRAIN OUTSOLE SRC rated slip-resistant design for optimal grip on any terrain.

Waterproof & Breathable

Developed with a unique 4-layer material:

Layer 1 water repellent and wear and tear-resistant outer layer

Layer 2 waterproof and breathable membrane

Layer 3 moisture wicking lightweight foam

Layer 4 antimicrobial abrasion-resistant lining

Sneaker-Like Fit

Inspired by the foot, the Dunlop® SnugBoot® follows the natural curves of the leg and foot to provide superior comfort. In addition, the Stability Fix locks in the foot to provide maximal support and prevent heel slip.

Your boots should give you ultimate protection. This is impacted a lot by the performance of your outsoles. As slipping and tripping occurs mostly during walking when landing on your heel and taking off from your toes, Dunlop pay special attention to these areas.

That's why they design outsoles that exceed your requirements on slip resistance and grip. Dunlop outsoles are additionally dirt repellent and wear resistant, assuring a long life time of your boots.

• SB = For safety footwear, this is the most basic level. These will have toe protection against a strong impact (200 joules).
• S1 = Same as SB, plus anti-static protection, energy absorption in the heel, and is resistant to fuel oil.
• S2 = Same as S1, plus resistant to water penetration or absorption through the shoe upper.
• S3 = Same as S2, plus midsole penetration resistance.
• S4 = Same as S1, but is made from waterproof materials and is fully waterproof.
• S5 = Same features as S4, plus midsole penetration resistance.
• S6 = Same as S2, plus fully waterproof, but not necessarily fuel oil resistant.
• S7 = Same as S3, plus fully waterproof, but not necessarily fuel oil resistant.

The SB-S5 levels above meet the EN ISO 20345:2011 standard, and S6 and S7 meet the EN ISO 20345:2022 standard.

If the above code portion ends with:

• L = non-metal midsole penetration resistance (tested with 4.5mm(dia.) nail)
• S = non-metal midsole penetration resistance (tested with a 3.0mm(dia.) nail)

If the standard includes any of the following letter codes, that means the footwear has those features.

• AN – Ankle Protection
• A – Antistatic properties
• C – Conductive footwear
• I – Electricity insulating footwear
• ESD – Reduces electro-static buildup or discharge to reduce risk of damage to sensitive electronic components and devices.
• CR – Cut Resistant Upper
• M – Metatarsal Protection
• WRU – Water Resistant Upper
• WR – The entire shoe is waterproof
• LG – Ladder grip
• P – Penetration resistance
• CI – Insulation against cold surfaces
• HI – Insulation against hot surfaces
• HRO – Heat Resistant Outsole
• SRA – tested on smooth ceramic tile with dilute soap solution
• SRB – tested on smooth steel with glycerol (mimicking oily or greasy conditions)
• SRC – tested under SRA and SRB conditions